It does not come with instructions and has multiple applications. If yours does not use the connector on the fuel line dont use common sense and try to tske the easy way by cutting the new fuel line at the new pump. There is no way to get the old line onto the new pump. In fact there is no way to get a new,line onto the new pump. Believe me. I spent $150 trying and finally broke down and bought another kit.
The way to do it is to disassemble the module. There is some info on the Green Hulk forum. Leaving the new hose on the new pump clip the connector off leaving a bare 5/16 pastic line. Heat up a cup of water and lube the end of the supply line fitting making sure that you have the oeteker clamp on the line, the blue lock ring and rubber grommet in place BEFORE you squeeze the clamp. Make sure the line coil orrientation is where you want too. Unless you are an octopus another set of hands is helpful. Remember the brown fuel gaige wire goes on the bottom. This is not an easy project but it is doable. I would buy this kit again but i probably wont have another FFI, ever.