Front Mount Receiver 2" Receiver For Ford F-150, Lincoln Mark LT. This particular front mount receiver hitch is rated up to 500 lbs. tongue weight and up to 9,000 lbs. Each is made of solid, all-welded steel for maximum strength and safety with a black powder coat finish to resist rust and corrosion.
Easy to install if you are mechanically inclined the only problem is the rear bolts that have to be snaked through the frame with wires, make sure you separate wires and use one on each bolt. You also must notch out vinyl faring clip under bumper, a good quality saber saw works best. tried it pulling out a Dodge 3/4 ton pickup worked great and held up as expected. Five stars.
Installed on my 2013 Ford F150. Perfect fit, install directions were very detailed and spot on. Took me about an hour and a half to install, which I thought was ok considering I did it with no vehicle lift and no help just me laying on my back. I do suggest using a wire coat hanger cut to use as a feed from the nut side of the rear bolt. the provided wire for the feed is great but feeding from the small hole to the larger hole makes it much easier.
Mounting aftermarket hardware can be a challenge on todays trucks, but this one fits well and goes on quite nicely. Only a modest effort to get it into position and the use of the included "bolt leaders" and away you go. It required about 3 hours and I'm no youngster.