About
All feedback (242)
- *****- Feedback left by buyer.Past monthVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- agnitsch (6126)- Feedback left by buyer.Past yearVerified purchaseGreat Buyer - Thank You!
- boatsmarketplace (52919)- Feedback left by buyer.More than a year agoVerified purchaseWe need more buyers like you. Easy transaction. Thank you!
- *****- Feedback left by buyer.Past yearVerified purchaseGreat communication. A pleasure to do business with.
- hemi426charger (4179)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- ebvc (92898)- Feedback left by buyer.More than a year agoVerified purchaseGreat communication. A pleasure to do business with.
Reviews (4)
Jul 28, 2017
X grip home phone on motorcycle perfectly
I used this x-grip in conjunction with a torque mount ball on my motorcycle to hold my phone while I ride. Ram mounts tough is high quality and works perfectly, I would definitely buy again.
Jun 07, 2021
Look Good but Fail Immediately
1 of 1 found this helpful I bought these, they looked nice, and had them installed on new rims I purchased and had tires mounted on. On 3 out of 4 of them the Honda logo center portion of the cap was peeling off and barely hanging on by the time I got home which was 15 minutes from the tire shop I had mount the tires on the rims. The adhesive used is obviously not up to the job. Total waste of money, but they were cheap and I am not out much. Just won't buy again.
Jul 28, 2017
Bobblehead Turn Signals
The stems on these turn signals are made of a rubber that is too soft. They droop a bit while sitting still and flop around in the wind like a bobblehead doll when driving down the road. I purchased some rear signals at the same time from another eBay vendor that are much more rigid and work better. I would not buy these front turn signals again knowing what I know now and I do not anticipate that they will last very long before the stems start cracking. I only bought them because they were DOT approved signals, but the rubbery stems are definitely an issue. Most everything else about the signals are fine and they pretty much match identical to the OEM signals on my 91 750 Nighthawk with the exception of the male pin connectors on the end of the wires, which are bigger than the male pins on the OEM turn signals so it was a bit difficult shoving them into the female receptacles. I will use them until the stems file at which time I will replace them with some that have more rigid stems.