About
All feedback (666)
- summitcollars (13135)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- *****- Feedback left by buyer.Past monthVerified purchaseThank you for your purchase!
- satisfyelectronics (219981)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- dentalemporium (40672)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- buyithere_18 (3674)- Feedback left by buyer.Past yearVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- billybob452 (4041)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (3)
May 09, 2018
Amazing product, works extremely well
I tried it out on several balloons, and it definitely works really well. I did one 12" inch latex balloon on the 30th of April and it's still floating today (the 10th of May). For smaller balloons you will have to be careful not to put very much, because the hi-float does add a little bit of weight to the balloon initially, and with small balloons that weight is much more significant. And like they say, be careful not to get it all over the neck of the balloon, because it does make it hard to tie the knot. Amazing product, if you use it properly you will not be dissapointed.
Feb 12, 2020
High quality precision-made chuck
This bit is very precision-made. I can use drill bits almost as small as a human hair, and even then the drill bit is still nicely centered and not wobbly. It's so much better than having to change out the madrel every time you use a different size bit. This chuck also happens to fit my Black and Decker cut-off tool.
Mar 03, 2020
Best aluminum repair that I have found, bar none.
1 of 1 found this helpful Practice a little with this stuff- it is amazing. It is WAY better than other aluminum soldering products. Recipe for success: Clean your aluminum really good. Apply heat to repair area. Quickly rub the rod across the repair area from time to time to see if it's hot enough. Once it leaves a trail of melted rod, back off the heat a little, but not totally. Make for dang sure you have ZERO pressure inside any tubing you are repairing. Leave shrader valve cores out completely. Aluminum oxidizes extremely fast at high temps, so try to get at least a thin film of this filler rod onto the repair area asap. Practice first on some scrap pieces. This stuff is by far the best aluminum repair product on the market that I have found. The key is to practice on scrap first. You will get the hang of it. Aluminum is very touchy because it has a fairly small window of temperature where it can be soldered, but practice, practice, practice! You WILL get it! Don't be afraid of aluminum! You can do it! I have repaired several refrigerator coils with this stuff. The only problems I have had- refrigerator coils tend to have multiple leaks waiting to happen in the same general area of the original repair, so don't automatically assume that the product failed. Just have the patience to leak-check the area and re-do if necessary. Oftentimes new leaks spring up after repairing the original leak. But have patience to deal with this issue. You will get through it. It's not because the product is defective. It's just the nature of aluminum.