About
All feedback (138)
- auto_engineparts (32070)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- jensonbooksinc (133957)- Feedback left by buyer.Past yearVerified purchaseFast payment. Smooth transaction. Thanks!
- tank-xo (3669)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- *****- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- acdcwireandsupply (147571)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- murdock80 (3210)- Feedback left by buyer.More than a year agoVerified purchaseHope to do business with Again, Extremely Quick Payment, A+++ Come Back Anytime!
Reviews (11)
Jan 06, 2020
So MUCH better than the stick on kind of wire managers
I'm working on a 48V 120 Amp Hour solar battery project and needed a way to tie down both the large cables (#2 awg welding cable) and the smaller battery management wiring (18 ga), of which there are many, inside the electrical cabinet. These take a little longer to install vs. the stick on kind because a hole has to be drilled in the back plate for each one. Well worth the extra time because these will not come loose once fastened. A #10 screw with a #10 washer works perfectly.
Apr 11, 2020
Excellent Bits, price is right
I purchased these bits a few weeks ago and just now had a chance to try them. Cut 1/4" birch plywood at 13 inches per min with 0.05 inch depth per pass, approx. 13,000 rpm. Performance of the bit was very good, clean with no fuzz, chatter or excessive vibration. Too soon to tell how long they will hold up with continued use.
Jan 02, 2020
Good Value but needs modifications
Overall both the container and top are well made and heavy duty. I had a problem getting a vacuum below 22" and thought my pump was having issues but it tested OK. With both ball valves closed the vessel did maintain the 22" vacuum with no apparent leaks. Traced the problem to the plastic hose & fittings. Tightened the hose clamps but it didn't help so I tossed them.
I purchased a 1/4" by 1/8" brass bushing, removed the screw in filter from the other ball valve and installed a proper HVAC Schrader connector that accepts a standard hose for HVAC gauges.
The rubber seal that goes over the lip of the container works fine but is annoying to install every time since it has to be removed to pour out the contents. I may try and use my bench top CNC router to cut a grove in the other side of the lid to accept an "O" ring when I get some extra time