Halogen Tail Light For 2007-2013 Chevy Silverado 1500 Left Clear/Red w/ Bulbs
Nov 16, 2021
Correct fit, easy swap out
Perfect fit and an easy replacement for my OEM light that was failed and would just fill with water. Plastic is a little thinner/lighter than OEM so we will see how durability is over time.
Replacement took me about 45 minutes, it would have been 20 but I had to pull back and redo some of the wiring for my brake controller and lighting plug that was spliced into the old lights harness. Which is obviously not this lights fault.
I will note though that the colors on this lights wiring harness don’t match the factory harness on my truck, but everything worked the same as the signal and ground wiring is all in the same locations.
SOLEX MIKUNI 40 PHH CARBURETOR CHOKES-4
Jul 14, 2021
Great aftermarket Choke option for Mikuni 40phh sidedrafts!
A perfect fit for my 40phh Mikuni Carbs. Machined out of aluminum, which is much lighter than the factory Mikuni ones, but with good finish. A perfect aftermarket option given that Mikuni does not make this part anymore, and the old timers who collect Mikuni parts don't often let the "non-standard" size chokes they own go. I was after a set of 34mm because I had 32 and 36 but wanted to try that in between size.
Front Black Drill Slot Brake Rotors And Pads For Silverado Tahoe Sierra Yukon
Nov 16, 2021
Good value, decent but not perfect quality.
Good looking rotors that I hope will function and last for a long time. Good valve, this pair was the same price as my local auto parts store wanted for just one rotor. They were well packaged and came labeled for drivers vs passenger side. And the provided pad set and retention clips fits correctly.
My only knock on these is they do not come with the drilled and counter sunk hole that the OEM ones do.. This hole is for a small bolt that holds the rotor to the wheel hub. They are not a firm requirement I suppose as once everything is together the rotor isn’t going anywhere, but having it makes reassembly easier.
I am a hobbiest machinist, so I have a drill dress and proper measuring tools and simply added these holes myself. But part of me thinks I should not have “had” too. It turned a 30 minute install into 60.