About
All feedback (18)
- nickyd_131 (668)- Feedback left by buyer.Past monthVerified purchaseAn exceptionally first-rate buyer. We can’t wait to do business with you again!
- wholesalefilterfactory (32964)- Feedback left by buyer.Past monthVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- pinchaser289 (450)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- handyhousewares (69575)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- white99gc8 (736)- Feedback left by buyer.More than a year agoVerified purchaseA++ fast payment!!
- *****- Feedback left by buyer.More than a year agoVerified purchaseGreat communication. A pleasure to do business with.
Reviews (5)
Dec 14, 2022
Exact OEM replacement
This is an OEM CH check valve. This fit right up and did what it's supposed to. The longest part of the job was removing the old, failed check valve. It was really stuck in there from time and a bit of corrosion. New valve works great.
Oct 28, 2023
OEM gasket, perfect fit
This is an OEM Subaru product in brand new condition. I replaced my stock exhaust from the rear pipe back. The gasket that was installed was worn out and needed a replacement. This sealed excellently and was exactly what I needed to ensure I didn't get any leak by from the new system.
Dec 08, 2020
Well made, great fit
1 of 1 found this helpful Our snowblower gets stored inside our 2 car garage during the winter. It becomes a tight fit in there with it and both vehicles and whoever parks near the snowblower is always worried that they might scrape it by mistake. We were just draping a towel over one side of the snow blower but it would never completely dry and made some spots on the snowblower develop rust. This cover completely covers our 24" 2 stage Toro, form fits it and it is made from high quality fabric. This should do a much better job allowing moisture out and protect the machine. I found it easiest to cover the snowblower from the handle side first with the side that has the logo. Then I pulled the rest of the cover over the front of the machine. Looking forward using this over the winter.