About
All feedback (563)
- duckquacker1048 (1994)- Feedback left by buyer.Past 6 monthsVerified purchaseQuick payment. Much appreciated!!
- impalaman6406 (2508)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for your purchase and fast payment from Dan's Vintage Trains!
- 5rosesfl (2841)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for your purchase, Spend time with the ones you LOVE...
- expresshobby (197137)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- nitrorchobbies (197956)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- gaspowersales (14006)- Feedback left by buyer.Past 6 monthsVerified purchaseQuick response and fast payment. Perfect! THANKS!!
Reviews (7)
Feb 04, 2024
Great for micro train layouts
If you intend to use this on a train layout, make sure that the equipment you intend to run is capable of hauling things around a curve this sharp, otherwise, it won't do you much good!
Mar 11, 2018
Great little heater
For the size and cost this is a very good unit for warming up a small chamber. I use one inside a 5-gallon bucket with a small thermostat unit for maintaining temperature for drying out filaments and it works very well. I found that in a chamber that size it will get up to 80*F very quickly, 100*F in about 5 - 10 minutes and will slowly climb to 120*F+ but this is much slower. Your results will vary depending on power supply, chamber insulation etc. Do run this with a thermostat unit so you will not overheat the chamber and cause safety issues! Overall this is a good unit for small scale chamber warming.
Jul 26, 2021
Great taps for general use tapping.
I use these taps for threading HP MJF 3D printed parts but they cut very cleanly and feel very sharp. The grind quality is superb and I see no issues for hand-tap applications.