About
All feedback (69)
- maremoto_marine (1143)- Feedback left by buyer.More than a year agoVerified purchaseGreat buyer, prompt payment, valued customer, highly recommended!
- usaspeed (20734)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- one-proud-daddy (8702)- Feedback left by buyer.Past monthVerified purchaseA+++ Ebayer ..Thanks for supportin us little guys! :)
- 2coats4u (5661)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- nailgunaccessories1 (34626)- Feedback left by buyer.Past 6 monthsVerified purchaseFast Payment. Thank you
- outdoorpowerequipment (121857)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
Reviews (2)
Nov 24, 2020
Worked great on stock Corvette 350 with ignition shielding
I was wanting low resistance wires for my 71 Corvette 350 with stock points and coil. These wires had only 20% of the resistance of the stock Delco Professional wires. The universal set had plenty of length to reach the front plugs through the Corvette ignition shielding along the side of the block. The lack of installed distributor boots made it easy to feed the wires backwards through the shielding. The 8 mm wires fit through my ~50-yr-old rubber wire looms with no issues. The black wire colors look stock, and my idle quality is much better with the low resistance wires and low-energy ignition.
Nov 30, 2023
A lot of anti-slip tape for the money
I ordered this to apply to my 29-year-old boat trailer that had long lost its anti-slip appliques on its fenders and step surfaces. I needed a mixture of 6-in and 9-in tapes to match the original anti-slip areas, but I was able to cover the 9-in areas with a 6-in and half of a 6-in piece cut to the same length and split down the middle. It all went on great and I have quite a few feet left if I should need to replace any of them in the future. And the roll arrived very promptly after I placed the order.