jase_astroboy on eBay

About

Location: AustraliaMember since: Jul 28, 2003

Feedback ratings

Last 12 months

Positive37- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (1,427)

sunny_computers (99847)- Feedback left by buyer.
Past month
Verified purchase
Great communication. A pleasure to do business with.
pgkdistribution (133)- Feedback left by buyer.
Past 6 months
Verified purchase
A+++
genuine_plus_premium_kitchenware (35609)- Feedback left by buyer.
Past 6 months
Verified purchase
Hope to deal with you again. Thank you.
wende1824 (8718)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
l0lwut (145)- Feedback left by buyer.
Past 6 months
Verified purchase
Many thanks for your purchase! Welcome back anytime.
cashstop (2968)- Feedback left by buyer.
Past 6 months
Verified purchase
Quick response and fast payment. Perfect! THANKS!!

See all feedback

Reviews (3)

2X KLEENMAID DISHWASHER DOOR CABLES SUITS MANY MODELS

Dec 21, 2017

Better than the original.

These replacement ropes were an easy fix. On my dishwasher both ropes had failed. Now the dishwasher door moves easily and will stay upright whilst partially open. Handy for letting the steam out and letting the dishes cool without having to open the door fully. The original ropes were very thin right where the end of the rope protrudes which is where both my ropes cracked. But these replacement ropes are much thicker in that critical spot so i am expecting no issues with these. So it looks like not only are these ropes a good replacement for the original ones , they also look to be better than the original ones.

CPU Intel Xeon E3-1260L Low-Power 2.4 GHz Quad-Core LGA1155 45W Processor CPU

Sep 15, 2017

Drop in replacement for a HP G8 Microserver

The CPU is FAST! For the power it consumes it achieves great results. A single thread PassMark 1642 and an multi thread PassMark of 6534. Perfect and cheap upgrade for the HP G8 Microserver. Simply removed the existing 2 Core Celeron and dropped in this 4 core (8 logical cores) Xenon replacement. Includes a small packet of thermal compound so nothing additional required. Runs within couple of degrees of the Celeron using just the same passive CPU cooler. I have not ran a full stress test to see if the stock cooler will be able to cope with all cores at 100% for an extended period but for normal server loads it has so far been flawless.

2.4G FS-iA6B 6Ch Receiver PPM Output iBus Port for Flysky i4 i6 i10 Transmitter

Dec 01, 2016

The FS-IA6B Receiver

A very easy to use receiver. With the receiver powered off. Insert the supplied bind plug into the B/VCC port. Power the receiver on, it should now be in bind mode. Select bind mode on your transmitter and in less than a second the transmitter and receiver have bound. Now power off the receiver and remove the bind plug. Power the receiver back on and the receiver and transmitter should connect and be ready for use. I use the i-bus connection from the receiver to my flight controller but there are many other supported connection methods. There are two reasons i use i-bus. With i-bus being digital the stick positions are rock solid and accurate. No tiny fluctuations due to conversion from PWM to digital. The second reason is that i use the Flysky FS-I6 transmitter which is normally a six channel transmitter but there is alternate firmware available on the internet that changes it to a ten channel transmitter. But in order to get the extra channels i need to use i-bus as only i-bus presents all ten channels to the flight controller. Has an LED to let you know what it is doing.

See all reviews