About
All feedback (163)
- kkworld66 (5642)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- tmsautoparts (136301)- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you.
- napa-autoparts (3325)- Feedback left by buyer.Past monthVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- premiumparts_eu (143511)- Feedback left by buyer.Past monthVerified purchaseGreat buyer, prompt payment, valued customer, highly recommended!!!
- xtechonline (1067027)- Feedback left by buyer.Past monthVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- zhongqflg6 (11542)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat Buyer , thank you , welcome to buy it again
Reviews (9)
Nov 23, 2017
Good value for the price.
I needed a replacement for a failed lift in a bar stool and this worked fine. Only problem is I needed a brushed chrome finish but they don't seem to do that. The polished chrome is hardly noticeable at the base of the stool so I am satisfied.
Nov 23, 2017
Internal diameter too small
Whilst the thread is correct for standard waste pipe fittings, the internal diameter at the lower end is too small to accept the part of the mating pipe that is supposed to fit inside the waste pipe so that the rubber ring will seal. i had to grind out the inside of the waste so that a standard U-bend fitting would fit correctly & seal.
Apr 03, 2021
Good value Odometer / Speedometer, works well.
2 of 2 found this helpful Pretty good low cost odometer / speedometer. Easy to fit as there are no wires, but came across a couple of issues: 1) the sensor is strapped to the bike forks with tie-wraps but although there is a a rubber pad supplied it can be moved no matter how tight the ties are, 2) the magnet for the spoke has a fairly soft plastic body, so you can't tighten that much and the part can move on the spoke. I put some tape around the spoke before fitting the magnet and that helps keep in place, but not 100% secure. I also found that the sensor registers better if the magnet is offset from the sensor centre line - I have found the same issue with a different make on my other bike.
Setup is fairly easy, though the instructions are basic. I found the calibration table for wheel (tyre) circumference to be quite close to actual. Measured values compared to GPS recorded data for a ride showed distance to be slightly low, but max speed to be slightly higher - which is odd as a calibration error would have meant both parameters were either high or low.
In use it is easy to read as the display is a good size. Display can be set to scroll through parameters, though the instructions don't mention this. I haven't had it long enough to determine charge life of the battery, but so far it looks good. I don't use the backlight (which works well) as I don't ride at night, but that might change the charge life.
A slight niggle is that if you choose to record in miles / mph the temperature reads if F, it will only show temp in C if set to kilometres / kph - it would be nice to be able to choose independently.