About
All feedback (814)
- *****- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- beparts (3459)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- bakt4kids (90335)- Feedback left by buyer.Past monthVerified purchaseGreat communication. A pleasure to do business with.
- radiantguy (1238)- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you.
- *****- Feedback left by buyer.Past monthVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- *****- Feedback left by buyer.Past monthVerified purchaseHope to deal with again
Reviews (11)
Jul 25, 2017
Typical High Quality from Denso, but be cautious of application
Having been a service manager at a midwestern motorcycle dealership and a mechanic for 45 years, I have seen lots of brands come and go, rise to prominence and then the quality tapers off. Denso has always been good stuff. The quality of these plugs is unsurpassed, it really doesn't get much better than this. They come pre-gapped so you may have to change the gap for your application, AND be aware, and more importantly watch your application! If you use a plug that requires the little nut on the tip to be removed to fit in your spark plug cap/connector, you need to look for a different number plug. These have the little nut CRIMPED in place so they don't unscrew, and if you try to remove them you can damage the plug. In the past, most companies allowed the nut to be unscrewed for use either way, but some vintage units still use the no nuts configuration.... Watch out for this and you will not be disappointed!
Jan 16, 2018
Great for the price, less money than a factory carb kit alone
Exact replacement. Easy to change. Only a couple of oddities. One, they give you a fuel filter that is too small for the inner diameter of the fuel line on the unit which is 1/4", the filter is a 3/16". The other is that the piece of primer line they give you is much too short. The snow thrower this was installed on has about 12" of primer hose, they supplied me with a section about 6" long. Luckily my primer hose was in good shape. Also, they show 3 gaskets included in the kit, mine showed up with only one. Again, the gaskets on my snow thrower were in good shape.
Installed the carburetor, put fresh gas in it, and it fired right up like the day it was new, and ran perfectly. I noticed the original carb had a no-tamper idle mix screw without a slot. This new unit had a small screwdriver slot making mixture adjustments to the idle circuit easier. Much less money than a factory replacement carburetor from MTD ($65 at my dealer) and less money than a carburetor rebuild kit ($37 at my dealer), and no hassle with cleaning the old one....
Jun 25, 2017
Motion Pro cables are the best
I have used Motion pro cables for years, and have never been disappointed. I encounter bikes with all brands of cables, O.E., Parts Unlimited, Moose (All Balls). None of them seem to match the icy smooth feel you get from the Motion Pro throttle cables. These folks are VERY precise about fit and will stand behind their product. While some of the Parts Unlimited cables may have a slightly better exterior appearance, they don't compare, having a somewhat sticky feel with the cable lining they use. This particular cable was used on a older Yamaha triple, a single cable setup without push-pull, so a easy pulling cable is a must. Tolerates tight bends and resists kinking quite well, as long as you don't get carried away and deform the housing. HIGHLY recommended, and if you need a custom length, there is no other place to go but MOTION PRO!