About
Reviews (1)
Dec 05, 2019
Good buy!
16 of 17 found this helpful Seasoned HVAC installer
Concerned only of installation in northern climates. Says in manuel heating under 20 degrees farenheit reduced efficiency greatly and not rated for heating under that temp.
Linesets are labeled standard but a metric flairing tool is best.
T-stat did have farenheit options just have to set it up.
Now to the wiring I was fortunate to install a unit in spain for my brother and learned there that the wall mounted head unit is where the line voltage goes first. In Ohio electrical code states a disconnect must be in eyesight of equipment. So units designed for US has line voltage to a condensers disconnect. Happy to install it for my father. He loves it in his apartment. Piggy backed line voltage off of a electric baseboard heater will be used as secondary heat source below 20 degrees.
Tools needed
Vacuum pump
Micron meter
Gauges for 410A with 5/17" adaptor
Screw driver
Wire strippers
Knife
Masonry drill with anchors
Flaring tool metric
Crescent wrenches
Pocket level
Drywall saw
Drywall anchor kit
Allen wrenches
Hammer drill
Impact gun with bit kit
Socket set
Outdoor wall bracket kit