About
All feedback (101)
- vanhngu-26 (199)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- leek2005 (2218)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for your purchase! Highly recommended!
- zicameau (2236)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- dbautomotive (22703)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- 21st-autoparts (27759)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- bungolawing (40161)- Feedback left by buyer.Past 6 monthsVerified purchaseQuick response and fast payment. Perfect! THANKS!!
Reviews (3)
Jul 31, 2017
Looking for help
First, I'd like to say this amp is awesome. I believe my issues are my own fault or a slight possibility of a defect. I've owned multiple kicker amps and they have all treated me well. Now for my issue....I'm posting this here because when i tried to contact the seller my message was too long. So I'll just paste it here and hope someone out there is smarter than me. If not, we're all doomed! Here goes:
recently bought this amp from you and installed it in my truck. I have it pushing 4 mb quart x line 6.5s 45w rms 4ohm (actually 3.7-3.9) speakers. I also have a cx1200.1 pushing some old kicker comp vr rated for 400w rms. The subs are 4ohm each and wired in parallel and are reading exactly 2 ohms. Gains on both amps are about 1/4 up. Both grounded to bare metal. Running 4awg ofc power cable to a distribution block with 4awg to the 1200.1 and 8awg to the 300.4. Reading 28v ac at the speaker output from the 1200.1. 300.4 was reading around 3v ac. On to the issue...everything sounds good but when i turn the volume up (3/4 max) and i get the bass going the 300.4 goes into prt while the 1200.1 keeps thumping. I checked the input on both amps and as the music plays it fluctuates from 12.6 to 14.1v dc on both of them. I tried multiple grounds with the same results. When i cut out the subs the 300.4 works fine. If the 1200.1 is drawing too much power i don't understand why the 300.4 is the only thing cutting out. And with the voltage only dropping to 12.6 i would think it should keep working. Am i missing something here? I thought about a new battery, maybe new alternator, and bigger power wire, but the amps seem to be getting enough power unless I'm mistaken. One last bit, my alternator output is 145A.
Sep 01, 2023
Good enough
The holes are too close together for rods with reels if you hang it on a wall. May be better from the ceiling but still most likely won't be able to fill it up. I ordered a couple sets and half of them were warped. I still mounted them on my wall but I don't trust it to hold much weight with the warped board pulling on the screws.
Jun 10, 2017
Worse than my old wipers
0 of 1 found this helpful Arrived quickly. Installation took about 30 seconds. Unfortunately there is about a 5" section in the center of both wipers that streak worse than the ones I replaced.