About
All feedback (724)
- 704subiparts (1916)- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you.
- thrift_or_die (2392)- Feedback left by buyer.Past monthVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- milestheking (2321)- Feedback left by buyer.Past monthVerified purchaseGreat communication. A pleasure to do business with.
- stringllc (37709)- Feedback left by buyer.Past monthVerified purchaseHope you enjoy!! Thanks!!
- jazzypants (3795)- Feedback left by buyer.Past monthVerified purchaseGreat communication. A pleasure to do business with.
- hiparts (385798)- Feedback left by buyer.Past monthVerified purchaseQuick response and fast payment. Perfect! THANKS!!
Reviews (15)

Sep 26, 2017
Authentic
Bought this because the local Ranch 99 didn't stock the usual Boba. I'm sure the is the Genuine article, but I prefer the 5 minute type. This one takes at least half an hour to cook and has a lot of gooey stuff from the dust, 1/3 of the pearls end up as dust event though it's tightly packed in the vacuum packaging.

Jun 09, 2020
You get what you pay for
2 of 2 found this helpful Most of the items are stamped metal with very sharp, protruding burrs. I ran them over a sharpening stone to remove the burrs. The feeler gauges didn't have this issue, luckily, and they are quite accurate as far as I can measure with my caliper. I hope they are made of real stainless steel (not Chinese "stainless"). They were oiled when I received them so no trace of rust.
The string action ruler is a joke, it's stamped metal with a screen printed image on it. The image is not aligned with the edge so the measurement is several steps off. I guess you can use it for relative measurements. I tried to grind down the edge, but it's still measuring one step lower than the actual value

Dec 28, 2017
Works fine
Easy to program and easy to use.
Had a little trouble figuring out how to connect my ancient gas heater (just two wires), didn't match any of the descriptions in the manual. Turned out I just had to connect to the W and R terminal....