About
All feedback (236)
- movingupgaragedoorcompany (49623)- Feedback left by buyer.Past monthVerified purchaseFast payment. Hope to deal with you again. Thank you.
- heltontool (95025)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- bigmikeelectronics (21253)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- slmracing (17112)- Feedback left by buyer.Past yearVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- lionparts_powersports (218786)- Feedback left by buyer.Past yearVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- hoerrracing (65515)- Feedback left by buyer.Past yearVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (21)
Feb 10, 2021
Fast, effortless aluminum cutting.
I used it in a Makita Cordless cut-off saw to cut numerous pieces of aluminum extrusions. It cuts through aluminum as if it were a hot knife going through a soft butter cube. This blade is a real time saver!
May 23, 2018
Much less cost than a new mower but requires your time to do it.
It came reasonably packaged and undamaged. The steel is the same thickness as the OEM product and all mounting hole points matched the original perfectly. If you do a deck swap like this I advise you to take several photos of the deck prior to removing the attached parts. I took photos but not enough of the central pulley area. I wasted a lot of time figuring out how to put that central area back together. On reassembly I used marine grease at all friction points. I sprayed the entire bottom and most of the top with undercoat spray to give additional protection against rust out. It takes patience to do the deck leveling procedure because each of the two procedures affects the other one. But, if you get it to specifications, the reward is beautifully cut grass.
Aug 16, 2017
Oil change kit
2 of 2 found this helpful I like the kit because it provides every item needed to complete an oil change the way the factory would do it. You don't have to measure anything. Just drain your oil following instructions in the manual (there are two drain plugs) and then put all the oil in the kit in after replacing the drain plugs with the provided washers using the correct torque setting, 15 FTLBs or 20 NM. One of the oil bottles is half size and that makes it so you don't have to measure anything. Just open and pour.