pm288mt2 on eBay

About

Location: United StatesMember since: Aug 19, 2003

Feedback ratings

Last 12 months

Positive42- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (463)

fcstore1 (4180)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
wondercity3 (35471)- Feedback left by buyer.
Past month
Verified purchase
Fast payment-highly recommended-Your business is much appreciated! Stay Safe
gf_computers (7562)- Feedback left by buyer.
Past month
Verified purchase
Thank you so much for your purchase ❤️❤️ Hope to do more business!
hbr2015 (19921)- Feedback left by buyer.
Past month
Verified purchase
Hope to deal with you again. Thank you.
xiaoyan2012 (14930)- Feedback left by buyer.
Past month
Verified purchase
Hope to deal with you again. Thank you.
a***m (949)- Feedback left by buyer.
Past 6 months
Verified purchase
Great item

See all feedback

Reviews (11)

Fender Amplifier Chassis Straps Pair, Large. 5-5/8 Inches, MPN 0990910000

May 08, 2017

Twin Reverb Top straps

These straps fit the Fender Twin Reverb, PA135 and "The Twin" 5 inch center to center. Good price, Fender original in factory package.

QTY-4 D2732A-3 INTEL D2732A 24-PIN CERDIP UOS PULLS LOT2 OF 4 PIECES

Jun 30, 2021

Great source of EEPROM replacements.

Used 2732A chips with slightly bent leads. Chips were received previously erased. After straightening pins and cleaning up with alcohol, all programmed perfectly. These are the second batch of EPROMs ordered from this site. Previous order was 12 2716 chips. Same story on bent pins, but straightened easily as well. All worked fine, although I had to erase those first.

2x Aluminum Laser Heatsink Mount for 12mm Diode Module Cooling USA

Nov 16, 2016

Universal 12 mm Laser heat sink

This heat sink fits 12 mm diode housings. It fits over the entire housing as it is about 1.5 inches long. I modified mine by sawing it off at about .75 inches so I could use the tail end of the 12mm module for mounting in the host. The screw is too long and sticks out. I ordered some 3M X 3mm set screws available at Rustybolt here on e-bay. My heat sink is used with a 12 mm M140 2W laser module from DTR Laser Shop again here on e-bay. It gets warm but is not too hot to hold. Nice quality machining.

See all reviews