pw44nan on eBay

About

Location: United StatesMember since: Oct 09, 2003

Feedback ratings

Last 12 months

Positive14- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (269)

cablesonline.net (183217)- Feedback left by buyer.
Past month
Verified purchase
Great communication. A pleasure to do business with.
tech_leaf_parts (98)- Feedback left by buyer.
Past month
Verified purchase
Hope to deal with you again. Thank you for shopping with Tech Leaf Parts! 🏆
bestdeallaptop (10589)- Feedback left by buyer.
Past month
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
fullcartdeals (8892)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
xcailau (35042)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
keeneyedeals (49873)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.

See all feedback

Reviews (6)

2x DC-DC Step Up Power Supply Module 3V 5V 12V to 19V 24V 30V 36V 1A Adjustable

Dec 31, 2016

About what you'd expect.

Convenient boost regulator assembly. The boards themselves are well made but the terminal blocks are very flimsy. I'd remove them and solder wires on for a permanent installation. Boost regulators of this type will run a microprocessor, but they're too noisy for audio without a linear post regulator and extra output caps.

820PCS 41Values 1Ω~1M ohm 1/4W 1% Metal Film Resistors Resistance Assortment Kit

Sep 27, 2017

handy assortment

After sorting my resistor box by value, I realized there were a lot of gaps. This assortment was the most convenient and cheapest way to fill those in. (Sorted into coin envelopes in a shoe box.) Other hobbyist part assortments weren't worth the money but this one was.

6 Pcs Black Plastic 2 x3.7V 18650 Type Battery Holder Box Case PS

Nov 03, 2016

Required rework

It's not obvious from the picture the two cells are wired in parallel. You have to cut one of the connections to use them in series. Then you have to add a wire. The plastic is soft and melts easily. Soldering to the rivets will melt them loose. I ended up soldering a wire halfway up one of the springs.

See all reviews