About

Location: United StatesMember since: Jul 22, 2001

All feedback (381)

  • 3910pplus (48323)- Feedback left by buyer.
    Past month
    Verified purchase
    Quick response and fast payment. Perfect! THANKS!!
  • e-mart2018 (498)- Feedback left by buyer.
    Past 6 months
    Verified purchase
    Quick response and fast payment. Perfect! THANKS!!
  • jrrapidpcrepair (283)- Feedback left by buyer.
    Past 6 months
    Verified purchase
    Good buyer, prompt payment, valued customer. Highly recommended
  • alexsorbet (10937)- Feedback left by buyer.
    Past 6 months
    Verified purchase
    •:*¨¨*:•.. Sehr Freundlich. •:*¨¨*:• Blitz - Schnell•:*¨¨*:•Vielen Dank •:*¨¨*:
  • priority_tire (481932)- Feedback left by buyer.
    Past year
    Verified purchase
    ★★★★★Excellent e-BAYer★★★★★Highly Recommend★★★★★
  • smokin135 (13293)- Feedback left by buyer.
    Past year
    Verified purchase
    Hope to deal with you again. Thank you.
Reviews (4)
New 16 ft Low Profile GPS Antenna for GARMIN GPSMAP 172 172C 176C 178 180 182
Feb 01, 2016
Works great.
I was gifted a GPS that came with everything but the antenna. I picked this one up and it works perfectly.
Stainless Steel Long Tube 1-7/8" Exhaust Headers 09-15 Cadillac CTS-V 6.2L LSA
Oct 15, 2022
Needed extensive modifications
Needed extensive modifications to clear the steering shaft and the #1 tube was far to close to the number 2 plug so it also needed to be modified.
1 of 1 found this helpful
STAINLESS STEEL LONG TUBE HEADER+Y-PIPE FOR CHEVY/GMC GMT900 V8 EXHAUST/MANIFOLD
Oct 30, 2018
You get what you pay for and it's not that bad
If you're looking for a perfectly fitting $300 set of headers and Y-pipe you need to realize you're better off buying the $600-700 sets for that, but this does fit and is a great value. Mine went in an 07 Avalanche. The headers fit very well but did need a bit of clearancing near the steering shaft, drivers front plug boot, and a bit over the passenger side frame where the starter cable passes over. Took 15 minutes with a torch and hammer to fix that. The y-pipe could be a lot better but it does fit and clears everything. The welds are of good quality and everything went in with no issues other than some normal massaging most low-dollar full lengths need. Edit, I did have to put a tack weld on the #4 cylinder at the flange. There was a pinhole they missed when welding and it was just enough to tick while running

About

Use this space to tell other eBay members about yourself and what you’re passionate about. Give people more reasons to follow you!1/1000