About
All feedback (2,375)
- chummly615 (427)- Feedback left by buyer.More than a year agoVerified purchaseGreat Seller, Quick Response and Fast Payment! A++++++
- prepbooks (217204)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- vcksns (4469)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- the65dartguy1 (9455)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- finishlinehobbies1 (9349)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- zoombooks_east (9354)- Feedback left by buyer.Past monthVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (2)
Sep 15, 2017
Yard Coring Aerator Works !!!
I was surprised, I didn't hold much hope for the grass Coring Aerator Device to work, but it performed very well ! It took some time and labor, but for a small grass yard, it works great ! Bit of advice, wear a shoe that does not have a flexible sole, like a sneaker. Best to wear a work boot as all the foot pressing of the device might hurt your foot's arch if you use sneakers. I would recommend this very highly ! Carry a soft face dead blow hammer to knock the metal tubes when it does become plugged. They will drop right out. I used this device after a big rain and it worked great. Will have to try it when the ground is more dry to see how it preforms in those conditions.
Sep 07, 2017
Watch out for BAD WELDS!!! DANGER!!!
5 of 5 found this helpful Received my Torin T43002A - 3 Ton - Double Locking Jack Stands on 9/6/2017. Flipped them upside down to see how the welds looked that joined the 2 halves of the stand base. The welds looked like they were done by a 7th grader from metal shop. A lot of the welds do NOT HAVE ENOUGH WELD PENETRATION into the base metal. It looks like a "cold weld". What I mean by "cold weld" is that the weld material is just deposited onto the surface of the base metal with a lack of weld penetration into the "base metal". There's also inclusions and undercutting defects present due to very poor welding procedures. Take a look at the posted pictures. Really BAD WELDS!!! Should I trust my life to these shoddy Chinese welds?