sat9144h on eBay

About

Location: United StatesMember since: Jul 11, 2013

Feedback ratings

Last 12 months

Positive15- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (85)

sneakercycle (78994)- Feedback left by buyer.
Past month
Verified purchase
SneakerCycle looks forward to your business again! Perfect, happy customer.
findrareparts (30364)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
65639_szcp5km (10878)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
*****- Feedback left by buyer.
Past 6 months
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
nawigksyqfi@Deleted- Feedback left by buyer.
Past year
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
*****- Feedback left by buyer.
Past year
Verified purchase
Hope to deal with you again. Thank you.

See all feedback

Reviews (14)

Broan/Nutone Replacement Charcoal Range Hood Filter 41F, 97007696 - NEW

Jan 25, 2023

Broan/Nutone P/N 41F Charcoal Range Hood Filter

OEM filter fits perfectly as expected

1 of 1 found this helpful

NuTone Bathroom Exhaust Fan Ceiling Clean Cover Roomside Series 110 CFM Air Vent

Aug 05, 2022

Great value at near new condition.

This was sold as an open box, new Nutone bathroom exhaust fan. It installed and worked properly, but was missing a hardware kit to secure the power cord. Since this product was sold at about a 50% discount from new, unopened condition. I was able to work around this small problem.

Carburetor Air Filter Fits Poulan 1950 2050 2150 2375 Walbro WT-89 WT-324 WT-391

Feb 14, 2018

Carburetor kit for a Poulan 2050 chainsaw.

This kit is a great value, but there were several fit issues with my Poulan chainsaw. 1. The outer diameter of the fuel and primer lines is too large to fit through the existing holes in the fuel tank. I had to slightly increase the diameter of these holes with a drill bit. 2. The supplied carburetor is mechanically different from the original Walbro carb. The choke linkage is larger and more complicated and interferes with the air filter box. I had to cut a hole in the plastic air filter box to allow full motion of the choke linkage. 3. The primer port is on the right hand side of the original carb and is not bent. On the replacement carb it is on the left hand side and is bent downward at a 45 degree angle. I had to carefully bend it to a straight position and re-route the primer line to attach to it. This was necessary to prevent interference with the throttle linkage. 4. After making these modifications, the saw started up immediately.

1 of 1 found this helpful

See all reviews