About
All feedback (315)
- eastwestx (743)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- priority_tire (482921)- Feedback left by buyer.Past yearVerified purchase★★★★★Excellent e-BAYer★★★★★Highly Recommend★★★★★
- elram-6686 (472)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- adistributors (862)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- bbn07 (4355)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- melisabarton75 (1881)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (19)
Dec 20, 2018
Very Thin and Flimsy
2 of 2 found this helpful If you are expecting the good old stiff silver "bubble wrap" type of shade, then you will be disappointed; this stuff is super-thin and flimsy.
Other reviews mention suction cups; I bought three of these and I didn't see any suction cups.
It says Jumbo, but there is nothing jumbo about it; the measurements are in the description.
They are not stiff enough to stand against the glass from the inside, so will have to be laid over the glass on the outside.
There are two problems with that: 1. the wind will blow them away. 2. It will streak up a clean windshield.
I got mine for the ridiculous low price of $1.60 each delivered; at that price, they have their uses.
Good to -secure- over the windshield before a snow or ice storm --- but one is not big enough to cover; it will take two.
Jan 08, 2019
Okay; but Needs Longer/Heavier Wires
I gave this 5 stars because it does the intended job for the low price that I paid.
However, there is room for improvement.
1. The wire length is about a foot too short. Yes, there is sufficient wire length for a very close splice to the existing (or new) wires; however, the area behind headlights is usually tight and such a close splice is stiff and inflexible, thus making it hard to do a neat job. If the wires were 18- or so inches long, the task would be much easier.
2. The supplied wires need to be minimum 12-AWG. If your headlights are drawing enough current to require Ceramic connectors, then they are drawing too much current for the wimpy little wires that are provided.
That being said, it is possible to carefully extract the supplied wires/terminals and replace them with longer wires of sufficient gauge to carry the load.
Dec 24, 2019
Very Satisfied with these Valve Extenders
If you have a dual-rear-wheel truck, especially one with stainless "simulators", then these are a necessity on the outside rear wheels, the 135-degree ones.
They turn the valve stem to look right at you.
They will not help at all, however, on the inside wheels; you must have flexible braided stainless extensions for the inside wheels.
I used the 90-degree ones, along with two of the 12-inch braided stainless, on my water pressure tank in the house; they have been there quite some time and haven't lost a speck of air.
The ones on the truck have never offered to leak.
I have no idea just where the 45-degree ones will ever be used, but someday I will find a use for them as well, maybe on the Cub Cadet.