About
All feedback (1,307)
- smghexagon (8326)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended. SMG Tools
- stevent1358 (220295)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- hyus-28 (3415)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- extremedigital2011 (7829)- Feedback left by buyer.Past monthVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- ztwholesale168 (417)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, Hope to deal again with you!
- *****- Feedback left by buyer.Past 6 monthsVerified purchaseThank you once again for your loyal custom and prompt payment. A+++++
Reviews (30)
Aug 03, 2018
Im keeping within its spec ,all is well
Using in scooter project, im using a different pitch belt drive, after removing the supplied gear with some considerable effort, the supplied one will not fall off ,
Using 24v 250w controller, motor drive 36tooth 15cmwheel with 88tooth , motor did not even got warm. Close to 20mph on a kids microscooter.
Mounting bracket is stronger than it looks in photos, feels like a well made motor,iv not taken it to bits to see inside.
Torque level is good,especially considering my gearing and controller .
Aug 27, 2019
Seems fine replacing 4 contact battery
Didn't check the old puffy battery,was down to 20 hours standby and had done the pop the case open trick.it had been left on charge for months, old one had 4 contacts . This new one has 3. Put it anyway. Battery life is great . It's not a phone I use much. Just using it to keep an old number active.
Jan 22, 2021
Factory set to low setting
1700 watt heater sold as 2000 watt Switch inside set to 999w setting in the factory .
It's not like older versions, it has minimal metal used for the grill ,used to provide thermal mass to improve output. Plastic case is bendy. Tiny relay now does all the big power switching ,instead of a big switch, half hour cutout is a pain.not adjustable it's hidden in circuit board.
Only after using a power meter did I know it was on half setting, I just thought it was really that bad. On the low setting heat output would significantly drop after 10 or 15 mins less than what a jml handy heater would output 500w.
Now it's on its highest setting I expect it to overheat and turn off at some point.
I doubt I will try or even be able to repair this when it does fail. The last two different types of these IV had ingot an extra couple of years out of, this one's likely to be a buy a new one immediately.
Delonge have really dropped the ball here. When set right to does kick out a good amount of heat. On low setting it makes a cone of cold air with a mildly warm bit in the middle.
With some luck the circuitry does something to reduce the strain on the little relay,the contacts inside will be very small and not last long making and breaking 1.7kw .
It works however everything about it shouts cost cutting ,I can squeeze the case and stop the fan ,perfect for stingey landlords,
Quality level is slightly above what I'd expect from wish
The cat like the box it came in.
Edit, tonight it overheated in about 10 minutes.