About
All feedback (856)
- calidigital2017 (404)- Feedback left by buyer.Past 6 monthsVerified purchasegreat buyer, thanks!
- ebyot (23240)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- hallmarkchannel (512)- Feedback left by buyer.Past 6 monthsVerified purchaseI do appreciate it. A+ All Day
- jabeeze (5913)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- thirteen_twenty (1080)- Feedback left by buyer.Past 6 monthsVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- envistia (42402)- Feedback left by buyer.Past 6 monthsVerified purchaseExcellent communication, fast payment. A+++ buyer. Thank you!
Reviews (5)
Dec 04, 2024
Exactly what I needed. Good quality...
Exactly what I needed. Good quality
Dec 03, 2017
Nice replacement valve stems
Fitment was perfect. Went on just like OEM.
Aug 10, 2018
Taller & stiffer springs for CRF50
5 of 5 found this helpful The inside fork tubes fit right up to an OEM crf50 fork setup. I’d recommend using these in that manner.
The upper fork tubes that are provided are machined extremely poorly, the snap ring detent is little to non-existent, paint is sticky and feels like spray can, welds have heavy undercut and large burnt thru areas.
The rubber fork boot seal is very very tight and you will need to keep a liberal film of grease on the forks to keep them from sticking.
With all that being said, I would buy these again with the intention of using just the insides without the fork uppers for reasons listed above.
The OEM plastic fork protectors bolt right up without a hitch. Brake cable and spring fit perfectly. Axle hole sizing is accurate and the metal is of good quality. So all in all, not a bad buy. Way cheaper than OEM so cant go wrong.