About
Reviews (10)
Sep 14, 2017
Will work for Volkswagens / G60 Girling 54 calipers...sorta
Overall these are well made with good tolerances and materials.
Needed these for a set of G60 Girling 54 calipers on an MkII Scirocco as they are very hard to find new / aftermarket.
Trimmed down to 59.75mm overall length (top of hex to end of pin) these will fit the VW calipers perfectly, including boots and hardware. Modification took about 15 minutes.
Jan 11, 2019
Excellent product, recommended.
Barrel nut requires 30mm crows foot wrench.
Pros:
- Very lightweight
- 6 point attachment makes for a very sturdy design
- American made
- Price point
Cons:
- Barrel nut missing coating on a single flat and required cleaning, painting. Once hand guard installed it'll never be seen. This could be an issue for some expecting 100% ready, though price point and overall quality makes up for it; almost 4/5 stars....
- Slightly tighter tolerances between barrel nut and hand-guard would be great
May 16, 2017
Not bad...
Installed on 16v VW
Pros:
- Fit well
- Plating (zinc?) holds up well to Hawk track pads
- Price
Cons:
- Weight, cross drilling didn't do much
- Materials lacking, standard drill bits cut very easily (installed press-in studs) vs tough factory rotors.
- Casting on non-machined surfaces. Wear gloves.
Could use some additional material removal from opposite side where stud flanges sit, would also save some weight.