About
All feedback (1,518)
- gocartgo (5079)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- be_niche (126)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- queenmicro (130631)- Feedback left by buyer.Past monthVerified purchaseThank you, Pleasure of doing business with - Hope to do business again!
- sionescu1995 (6041)- Feedback left by buyer.Past monthVerified purchaseAwesome buyer! A pleasure to do business with.
- wehavethatitem (19059)- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you. A+++++
- second.sale (4081826)- Feedback left by buyer.Past monthVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
Reviews (31)
Jan 21, 2018
Good, with some small reservations
The product works as advertised, however, I'm not sure the product is robust enough for an automotive environment -- their might be corrosion problems in long-term use. The second problem is that the round circuit board at the base extends out from the brass bayonette base such that the lamp may not fit in all sockets. In particular, it will not fit in the tail/brake light for BMW motorcycles made from about 1975 into the 1980's. The reflector in the lamp housing interferes with the lamp circuit board such that it will not go far enough into the socket.
Jul 05, 2018
Terrible quality, caveat emptor.
These are terrible. The insulating plastic between conductors is very low melting point, so it's impossible to solder the wires onto the terminals without the insulator melting, and the center post shifting to one side. There's an undocumented shorting wire between the center and the barrel, so you can't use this connector so supply power. The connection between the barrel and the wire terminal that goes to the barrel is only crimped, and badly, at that, so you'll have to solder that crimp if you want the barrel connection to be reliable. The only way to use these is to us a male connector (or better yet, a custom "fixture") to hold the center pin in place whilst you solder the connections and the bad crimp. If you don't, the center pin will move around due to the plastic that holds it melting.
May 02, 2018
Works as advertised. One should be comfortable with power wiring or you can hurt yourself.
Works with the stock firmware, but I (and many others) reflash them with Tasmota firmware that lets you control the load with MQTT. If you are not experienced wiring up AC power wiring, this can be a dangerous product -- you can kill yourself or burn your house down if you do a crap job on the wiring.