Fast shipment, packaging was secure, very nice coin as pictured, great value, i would purchase from again A+++ seller.
a***n- Feedback left by buyer.
Past 6 months
Verified purchase
Terrific seller. Great communication and would buy from again. Item just as described with great packaging and shipping. Thanks! A+
c***s (15)- Feedback left by buyer.
Past 6 months
Verified purchase
Shipping was very fast. Packaging protected the wooden scales inside very well. The skills I purchased were described perfectly with a picture that demonstrates that what I received was what was advertised. Value was OK.
u***d (574)- Feedback left by buyer.
Past 6 months
Verified purchase
Nice coin as shown. Delivery time a little long, which had me concerned so I contacted seller. Good communication. Good ebayer
3***1 (284)- Feedback left by buyer.
Past 6 months
Verified purchase
Item arrived as described in a timely manor and packed well
e***u (225)- Feedback left by buyer.
Past 6 months
Verified purchase
10/10 transaction! Seller with great communication and fast shipping time. Very happy with my purchase.
These Jen Mfg foam brushes are much better than the cheaper foam brushes out there. In my past experience with different / cheaper foam brushes, that foam was not as dense, was floppy, and I found to be not as durable as these. I will only buy Jen Mfg brushes from now on.
Titebond 5175 Glue, Cold Press For Veneer, 1 Quart, Brown
Feb 02, 2021
Great glue, no bleed-through, quick setting (but not too quick)
I have now glued down about 8-10 2" veneer squares and am happy with how this product has so far performed. Using a light coat of glue I can place and position the veneer and have maybe 2 minutes to make adjustments to it's location before it is pretty well stuck in place.
The instructions (If Im remembering correctly) say 45 minutes to 2 hours for curing, but I have been removing the clamps holding my veneer pieces in place after about 20-25 minutes with so far no adverse effects (curling, movement, etc)
I have not had any bleed-through on 1/42" veneer.
At first I did wish that it didnt quite flow as easily as it does, that it was very slightly thicker. Upon using it more however, I decided that if it was thicker then it would be harder to get a thin coating on small pieces probably. I have learned how to work with it and it isnt an issue or concern any more.
This has been a very good glue for my application and would certainly not hesitate to purchase again (but I think a quart of this will last me a long, long time)
.