worshipviolin on eBay

About

Location: United StatesMember since: Jun 24, 2003

Feedback ratings

Last 12 months

Positive39- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (570)

rznewyork (621)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
uherebuy (81694)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
fcxkj001 (4453)- Feedback left by buyer.
Past month
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
shopmedsupply (8311)- Feedback left by buyer.
Past 6 months
Verified purchase
Hope to deal with you again. Thank you.
jiangchuanyi (5105)- Feedback left by buyer.
Past 6 months
Verified purchase
Great communication. A pleasure to do business with.
everydaygadgetz (258713)- Feedback left by buyer.
Past 6 months
Verified purchase
Great communication. A pleasure to do business with.

See all feedback

Reviews (4)

Stainless Steel Striker Indicator for Ruger SR9, SR9c, SR40, SR40c, and SR45

Apr 20, 2020

Nice

Easy to install, as long as you have the correct size punch tool. Looks a lot nicer than the cheap-looking plastic factory thing... When the gun is holstered, it only takes a quick glance to see if the gun is cocked. I like it.

Bird Blinder - Bird Repellent Scare Tape (Triple Thick) - 147 feet x 2 inch D...

Apr 20, 2018

Works... sometimes....

It only frightens the birds away when the wind is blowing it around. When it’s calm, the birds aren’t bothered by it at all.

Double Diamond Black Yikes 3.0 Connector 1312-BLK

Apr 27, 2020

Not What I Hoped For

I dropped it in a G19 Gen 5 MOS, then the slide wouldn’t rack. With difficulty, I finally got the gun disassembled again, took the connector out, made sure that it had the same angle as the stock connector (again), then put it back in. The rack would rack again, but the trigger was stiffer than the stock trigger. After removing and adjusting the angle of it, over and over, it’s better, but not that good. The “wall” still exists. I’m not sure if it decreased at all. It’s gotten a little better after dry firing about 300 times. The pull is shorter, and the reset might be a tiny bit quicker (but sounds a little funny... kind of a plastic thud). I’m thinking of going back to the stock connector or a Ghost (which I’ve always had success with), because it felt a little better. The weight of the pull didn’t drop that much compared to the stock connector (that I had polished). My experience just wasn’t “magic” like some others have had. I kind of feel like it was a waste of money. It just didn’t work for me.

2 of 2 found this helpful

See all reviews